Описание

  • Energy savings thanks to EcoMode
  • Increased capacity thanks to intelligent functions
  • Optimized performance
  • Time-saving initial start-up with fast-clip mounting system and quick wiring
  • Wireless settings via NFC
These devices have been specially designed for use in accumulation roller conveyors. Their compact design allows for installation between rollers below the transport level.They're equipped with their own sensor optics, and object detection is handled by externally connected sensor technology. Settings are entered via wireless NFC, which is even possible in the de-energized state. Thanks to the innovative fast-clip mounting system and quick wiring, the devices are installed and ready for use in no time flat.
Service Life (T = +25 °C) 100000 h
Electrical Data
Supply Voltage 20,6...30 V DC
Current Consumption Sensor (Ub = 24 V) < 16 mA
EcoMode yes
Switching Frequency 100 Hz
Response Time 5 ms
Temperature Range -40...60 °C
Number of Switching Outputs 2
Switching Output Voltage Drop < 0,9 V
PNP Switching Output/Switching Current 200 mA
Short Circuit Protection yes
Reverse Polarity Protection yes
Overload Protection yes
Logic yes
Single Discharge yes
Block Forwarding yes
Solenoid Valve yes
Automatic Roller Shutdown yes
Protection Class III
Mechanical Data
Setting Method NFC
Housing Material Plastic
Degree of Protection IP65
Connection M12 ? 1, 4-pin
Cable Length 100 cm
Pneumatic Solenoid Valve Unit
Valve no. K04
Supply Voltage Valve 19,2...28,8 V
Current Consumption Valve 86 mA
Valve temperature range -15...50 °C
Operating Pressure 4...7 bar
Nominal Width 0,8 mm
Nominal flow rate 1 -> 2 20 NL/min
Nominal flow rate 2 -> 3 100 NL/min
Supply-Line Connector Pipe 2? 8?1
Working-Line Connector Pipe 4?1
Valve function 3/2-Way
Switching function NC
Output
PNP NO/NC switchable yes
NFC Receiver Category 3 yes
''